Signal SS650 Manuel d'instructions télécharger pdf (Page 9)

-7-

Wiring Connections:

Black: (Pin 2) Ground - Connect the black wire to the negative of the battery, or

to a good chassis ground. Be sure to use minimum size #16 AWG wire.

Red: (Pin 1 for SS650 and Pins 1, 4 & 8 for LCS652) Power - Connect the red

wires to +12 VDC. It is strongly recommended that you connect to a +12

VDC source that is present only when the vehicle ignition is in the on

position. A power relay may also be used. Be sure to use minimum size

#16 AWG wire for Pin 1 and #14 AWG wire for Pins 4 and 8. Connect

the red wires from Pins 4 & 8 through an appropriate user supplied fuse

(up to 20 amps). It is highly recommended that you appropriately fuse

these input wires. Damage to the siren caused by shorts in the devices

connected to SW1 or SW2 will not be covered under warranty.

Brown: (Pins 7 & 12) Speaker Leads - Connect one lead to each terminal or lead of

the speaker. Be sure to use minimum size #16 AWG wire.

White w/Orange Stripe: (LCS652 Only - Pin 6) SW1 Output

This lead supplies power to the device connected to SW1 (the second

switch from the left). Be sure to use minimum size #14 AWG wire.

White w/Brown Stripe: (LCS652 Only - Pin 3) SW2 Output

This lead supplies power to the device connected to SW2 (the third

switch from the left). Be sure to use minimum size #14 AWG wire.

Optional Connections:

Green: (PIN 10) AUX or Horn Ring - Used for remote (Aux.) HORN control.

Connect to horn ring circuit or remote switch. Siren is shipped with

positive voltage activation defaulted (apply +12VDC for activation). For

vehicles with negative activation (connect to ground for activation), the unit

must be opened up and have the Aux. Horn polarity jumper switched. Refer

to pages 3 & 4 for further details.

NOTE: Cut this lead short if not used, and insulate with electrical tape.

Testing

Test all siren and light functions after installation to assure proper

operation. Test vehicle operation to assure no damage to vehicle.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Signal SS650 Manuel d'instructions Page 9